n    <h1>Pedders Heavy Duty Rear Suspension Kit. Nissan NV300</h1>n    <p>Improved load carrying and towing for your van.</p>nn    <p>Are you finding that your NV300 suspension is struggling with the demands you put on it?</p>nn    <p>Then Pedders Suspension have the solution for you.</p>nn    <p>This kit is our “constant load” kit designed for those who regularly run laden. It features an upgraded rear spring, and shocks designed to match. We recommend a minimum load of circa 250kg with this kit. Operation in the unladen state may result in a harsher ride than is desirable.</p>nn    <p>Results vary dependant on weight distribution, but as a simple guide, assuming your van is well loaded, this kit will <strong>RAISE</strong> the rear from where it currently sits by 25-30mm. Please check that this will not lift it too much prior to ordering</p>nn    <p>This kit is primarily for heavily laden vans. In most cases, campers, will not be suitable for this kit as they are not normally heavy enough. Refer to the measurements above. Such vehicles will still benefit from our upgraded shocks Pedders part 121274, which will reduce wallowing and bounce on well laden vehicles.</p>nn    <p>These components replace the original items. No other modifications to the vehicle are necessary.</p>nn    <p>If your loads vary between completely empty and fully loaded, please consider using one of our airbag kit, Pedders part number 49717415. If you have a lot of weight biased towards the front we can assist with this also. Still not sure this is the correct kit for you? Have further questions? Then please do get in touch with one of our team here at Pedders who will be able to assist.</p>nn    <h2>Key features</h2>n    <ul>n        <li>Heavy Duty Kit</li>n        <li>Improved load carrying and towing ability</li>n        <li>Premium Grade spring</li>n        <li>Uprated shocks for improved stability and load control</li>n        <li>All backed by our 2 year / 25,000 mile warranty</li>n    </ul>nn    <h2>Vehicle Height Information</h2>n    <p>Front: Approx. 30mm higher than standard in the unladen condition</p>n    <p>Notes: Heights should be measured as shown in the secondary picture.</p>n
<!--
Gentime

Total:     0.387 s
Tween:     0.383 s
Xref:      0.000 s
Tagwiz:    0.000 s
Offers:    0.000 s
Last:      0.004 s

Memory:    73.19 MiB

-->